A custom vanity top maker based in georgia will design vanity tops as long as 140 inches and as deep as 30 inches.
Changing bathroom vanity top.
Disconnect the drain pipes from the existing sink unit using a pipe.
Remove screws underneath cabinet.
How to remove and replace a bathroom vanity top step 1.
Find the studs and position the vanity locate the wall studs and mark them a little higher than the top of the new vanity.
Remove the doors from the vanity cabinet using a screwdriver to make it easier to work.
Studfinder tape measure level pencil drill with screwdriver bits jigsaw as needed coping saw as needed small profile gauge as needed caulk gun.
Buy your new vanity top according to these measurements.
Set the vanity in place.
Start by cutting off water and disconnecting and removing old fixtures.
Turn off the main water supply to the bathroom.
Measure for the new vanity top.
Measure the dimensions of the existing vanity top using a tape measure.
Figure out the center every bathroom sink or vanity top has three holes cut at.
Cut caulk between backsplash and vanity with utility knife.